Cabling

WHAT IS THE BEST TYPE OF CABLE TO USE?

Pulse-Eight products use HDBaseT standard that utilises regular Cat cables. Typically, the minimum cable use on a neo system is Cat5e but you could increase the range and bandwidth by using higher tier cables such as Cat6, Cat6A & Cat7 which have stricter shielding requirement and therefore reduces the data loss between data pairs.

We highly discourage patch cabling as this might degrade the signal. Whenever possible, use a long, single high-quality cable for each HDBaseT port as this allows the system to function at its best peak efficiency.

We do not recommend the use of pre-made leads unless you are certain of the correct specs (i.e., solid core 568B), the use of lower quality cables will lead to signal degradation and quality of the transmission.

Please note Copper Clad Aluminium (CCA) cables are not supported. Due to the inherent properties of a CCA, this will cause an HDBaseT performance issue.

SHIELDED CABLES

If you prefer shielded FTP cables, please ensure compatible shielded features are used such as grounding & termination. A badly terminated cable can cause interference instead of eliminating it.

CABLING BEST PRACTICE

Our recommended and best practice policy is to use a straight cable directly from the Pulse-Eight matrix to the receiver. This will ensure the best quality of signal and achieve maximum distance. You can find further information on "HDBaseT Best Practices" on the HDBaseT Alliance website.

WALL PLATES & PATCH PANELS

If the patch panels are terminated correctly, there is minimal loss of distance. The use of wall plates and patch panels, however, has the potential to cause increased resistance on the cable if not done correctly, introducing pinch points for signal transmission, and could reduce advertised transmission lengths. Instead of using RJ45 wall plates, you can use brush plates to maintain the neat finish.

CONNECTION TERMINATION

Whenever possible, use full plastic encasement. We do not recommend metal ones to avoid grounding leaks to Pulse-Eight products. Terminate the cabling using RJ45 connectors to the 568B wiring standard. (See diagram)

 

IMPORTANT: Please note that local building regulations may apply to the installation of cabling in properties. It is important to check building regulations to guarantee that you are in accordance with the laws of your territory.

IR Flasher & Receiver

The neo:X+ (P8-HDBT2-U-FFMJ1210-S), neo:XMR (P8-HDBT2-U-FFMJ108-S) & neo:XSR (P8-HDBT2-L-FFMJ66-S) uses a 12 V powered IR board designed specifically to work with 12 V IR flasher/receiver.

See Product Description for compatible IR receiver and flasher.

Do not mix and match 12 V and 5 V IR receiver/flasher for different video matrixes/extenders as they might cause irreparable damage to the board.